Notes reqardinq balanced operation:
If you are using two B.A.F.s in balanced operation both units' internal switch settings must be the same.
When two B.A.F. are connected for balanced operation they automatically utilize the balanced circuitry without adjustment of the units.
D. CONNECTIONS
Caution: When making connections to this component or any other always make sure the power amplifier is OFF and the preamplifier is in the Mute or standby mode.
Install the unit(s) on a clean, level surface away from excessive heat or moisture.
The Krell B.A.F. can be connected to your system in four different configurations. Connection details of the four options are presented below. Follow the instructions that are appropriate for your system.
I. Sinqle unit,
Connect the
Operate your system in the same manner as before the B.A.F was installed.
2. Sinqle unit,
Connect the Tape outputs of your preamplifier to the inputs of the B.A.F. Connect the outputs of the B.A.F. to the Tape inputs of your
preamplifier. Be sure to maintain correct left and right channel connections.
When listening to the B&W speakers, the Tape Monitor should be set to the position corresponding to the output return from the B.A.F. The Input Selector is used to select a source for listening.
Caution: In this configuration the Input Selector must not be set to the input connected to the B.A.F. output. As with any tape recorder or surround processor, this will create a feedback loop that can cause a squeal. At high volume settings this could potentially damage the loud speakers.