Installation
Setup for IR Control
1.Connect Decoder to audio system. With the audio system turned off, use an RCA patch cable to connect from the Decoder’s outputs to a source input on the audio system. Use an IR link cable or mono patch cable with
2.Select IR function. Set the source/function selector switch on the Dock to IR for infrared con- trol of the iPod.
3.Power Dock and Decoder. Plug the power adapters into AC power receptacles and connect their output leads to the device power jacks.
4.Dock iPod. Put the iPod in the Dock with the appropriate iPod adapter.
5.Turn on audio system. Power up the audio system and select the source input you’re using for the iPod. As long as the iPod is playing, you should hear it through the audio system.
6.Program audio system. Configure the audio system for IR control of the iPod.
Firmware Update
From time to time Russound may offer updated firmware for the BGD1 iBridge Dock. You can download updated firmware from the Document Center at www.russound.com.
1.Disconnect power. Unplug the power adapter from the Dock.
2.Select program function. Set the source/ function selector switch on the Dock to PRGM.
3.Reconnect power. Plug the power adapter into the Dock’s power jack.
4.Connect programming cable. Remove the rubber plug from the OS update port on the Dock. Connect an Advanced Programming Cable, Russound part number
5.Run update program. Run the update soft- ware on the computer to load the firmware into the Dock.
6.Disconnect power. Unplug the power adapter from the Dock.
7.Restore source selection. Return the source/function selector switch on the Dock to the previous source setting.
8.Reconnect power. Plug the power adapter into the Dock’s power jack.
6