Haier HSU-12CKAS(R2DB) Comfortable Sleep, Healthy airflow Operation, Operation Mode

Operation

Comfortable SLEEP

Press	SLEEP	button ,	the remote controller will
show	,	and then achieve to the sleep function.
Press again this SLEEP			button , the sleep function will
be cancelled.

Operation Mode

1. In COOL,DRY mode

1 hours after SLEEP mode starts,temp.will become

1OC higher than temp.setting.After another 1 hours, temp.risesby 1OC futher .The unit will run for further 6 hours then stops Temp. is higher than temp.setting so that room temperature won’t be too low for your sleep.

SLEEP operation starts SLEEP operation stops

		Approx.6hrs
	1 hr	Rises 1OC
1 hr	Rises 1OC
Temp.setting		Unit stop

In COOL, DRY mode

2.In HEAT mode

1 hours after SLEEP mode starts, temp will become

2O C lower than temp.setting. After another 1 hours, temp decrease by 2 OC further. After more another 3 hours, temp.risesby 1 OC further.The unit will run for further 3 hours then stops.Temp. is lower than temp. setting so that room temperature won't be too high foryour sleep.

Temp.setting		Unit stop
1 hr	Decreases 2OC
1 hr	Decreases 2OC
	3 hrs	3 hrs
SLEEP		Rises 1OC
		SLEEP
operation starts		operation stops
In HEAT mode

3.In AUTO mode

The unit operates in corresponding sleep mode corresponding sleep mode adapted to the automatically selected operation mode.

4. In FAN mode

It has no SLEEP function.

5.When quiet sleeping function is set to 8 hours the quiet

sleeping time can not be adjusted.When TIMER function is set,the quiet sleeping function can't be set up.After the sleeping function is set up,if user resets TIMER function, the sleeping function will be cancelled; the machine will be in the state of timing-on,if the two modes are set up at the same time,either of their operation time is ended first,the unit will stop automatically,and the other mode will be cancelled.

Note

When TIMER function is set, the sleeping function can’t be set up .After the sleeping function is set up,if user resets TIMER function, the sleeping function will be cancelled; the machine will be in the state of timing-on.

Note to the power failure resume:

press the sleep button ten times in five seconds and enter function after hearing four sounds.And press the sleep button ten times within five seconds and leave this function after hearing two sounds.

Power Failure Resume Function

If the unit is started for the first time, the compressor will not start running unless 3 minutes have elapsed. When the power resumes after power failure, the unit will run automatically, and 3 minutes later the compressor starts running.

Healthy airflow Operation

1.Press to starting

Setting the comfort work conditions.

2.The setting of healthy airflow function

Press button to enter additional options,Press this button continuously, the louvers location will cycle between in the following three locations, to choose the swing location

what you needed,and then press button to confirm.

Healthy	Healthy	Present
airflow	airflow
upwarder	downwarder	position

3.The cancel of the healthy airflow function

Press button to enter additional options,Press this button continuously, the louvers location will cycle between in the following three locations again,and then press button to cancel.

Notice: Do not direct the flap by hand. Otherwise, the

grille will run incorrectly. If the grille is not run correctly, stop

for a minute and then start, adjusting by remote controller.

Note:

1.After setting the healthy airflow function, the position grill is fixed.

2.In cooling, it is better to select the mode.

3.In cooling and dry, using the air conditioner for a long time under the high air humidity, condensate water may occur at the grille .

4