Haier HSU-24LEK13/R2(DB), HSU-09LEK03/R2(DB) Maintenance, Use the timer effectively

Maintenance

For Smart Use of The Air Conditioner

Setting of proper room	Do not block the air inlet
temperature	or outlet
Proper
temperature

Close doors and windows	Use the timer effectively
during operation
During cooling operation
prevent the penetration
of direct sunlight with
curtain or blind
If the unit is not to be used	Use the louvers effectively
for a long time, turn off the
power supply main switch.
OFF

Remote Controller	Indoor Body
	wipe the air conditioner by using a
	soft and dry cloth.For serious stains,
Do not usewater,wipe the controller	use a neutral detergent diluted with
	water.Wring the water out of the
with a dry cloth.Do not use glass	cloth before wiping,then wipe off the
cleaner or chemical cloth.	detergent completely.

Do not use the following for cleaning

Gasoline,benzine, thinner or cleanser	Hot water over 40OC(104O F) may
may damage the coating of the unit.	cause discoloring or deformation.

Air Filter cleaning

Open the inlet grille by pulling it upward.

Remove the filter.

Push up the filter's center tab slightly until it is

released from the stopper, and remove the filter downward.

Clean the filter.

Use a vacuum cleaner to remove dust, or wash the filter with water.After washing, dry the filter completely in the shade.

Attach the filter.

Attach the filter correctly so that the "FRONT" indication
is facing to the front.Make sure that the filter is
completely fixed behind the stopper.If the right	Once every
and left filters are not attached correctly, that	two weeks
may cause defects.

Close the inlet grille.

Replacement of Air Purifying Filter

1.Open the lnlet Grille

Prop up the inlet grille by using a small device named grille-support which located in the right side of the indoor unit.

2.Detach the standard air filter

Slide the knob slightly upward to release the filter, then withdraw it.

Detach old Air Purifying Filter

3.Attach Air Purifying Filter

Put air purifying filter appliances into the right and left filter frames.

4.Attach the standard air filter

(Necessary installation)

ATTENTION:

The white side of the photocatalyst air purifying filter face outside,and the black side face the unit The green side of the bacteria-killing medium air purifying filter face outside,and the white side face the unit.

5.Close the Inlet Grille

Close the Grille surely

NOTE:

The photocatalyst air purifying filter will be solarized in fixed time. In normal family, it will be solarized every 6 months.

The bacteria-killing medium air purifying filter will be used for a long time,no need for replacement. But in the period of using them ,you should remove the dust frequently by using vacuum cleaner or flaping them lightly,otherwise , its performance will be affected.

Please keep the bacteria-killing medium air purifying filter in the cool and dry conditions avoid long time directly sunshine when you stop using it,or its ability of sterilization will be reduced.

5