
C O N N E C T I O N S
Connection to a TV (Progressive)
1
Using component video cables (not included), connect the COMPONENT VIDEO OUT terminal on the rear of the
2
Using the audio cables, connect from the AUDIO OUT or LINE OUT AUDIO (red and white) terminals on the rear of the
Turn on the DVD-VCR and TV.
3
With the unit in stop mode, set the Alt video output to Component: Progressive in the Display Setup menu (see pages 60~61) or press the P.SCAN button on the front panel Progresive Scan mode prompt screen appears. Then press ENTER and progressive will be output.
White | Red | Blue |
| ||
| Green | Red |
|
| |
Audio Cable | Component Cable | |
|
| |
|
| (not included) |
Red | Blue Green | |
Red White |
|
|
4
Press the input selector on your TV remote control until the Component signal from the
To see the progressive video output,
-Consult your TV User’s Manual to find out if your TV supports Progressive Scan.
If Progressive Scan is supported, follow the TV User’s Manual regarding Progressive Scan settings in the TV’s menu system.
-Depending on your TV, the connection method may differ from the illustration above.
Note
What is "Progressive Scan"?
Progressive scan has twice as many scanning lines as the interlace output method. Progressive scanning method provides better and clearer picture quality.
The Component Video jacks only output video from the DVD player. To view video from the VCR, you must have the Video Out (Yellow) or RF Out jack connected.