Connecting yepp to PC with USB cable
3 Plug one end of the USB cable into the USB port on the back of the PC.
4 Connect the opposite end of the USB cable to the USB cable port on the bottom of the yepp.
●If you disconnect the USB cable from your PC while
implementing a command or initializing during USB driver installation, your PC may not function correctly.
● The yepp will automatically turn on.
5 | USB driver is installed with a message saying that it | USB |
| ||
| is searching for a new device. You may not see the | |
| connect | |
| display screen during installation. | |
|
| |
| Go to the device manager to check that installation | cable |
| has been successfully completed. | |
|
|
6 Upon installation of the USB driver "SAMSUNG
| REC / ENC |
MODE | VOL |
Note :
HowHow toto checkcheck USBUSB driverdriver
Windows 98:
Control Panel ➝ System ➝ Device Manager ➝
Universal Serial Bus controllers/Samsung
Windows 2000:
Control Panel ➝ System ➝ Hardware ➝
Device Manager ➝ Universal Serial Bus controllers ➝
USB Mass Storage Device Windows XP:
Control Panel ➝ System ➝ Hardware ➝
Device Manager ➝ Universal Serial Bus controllers ➝
USB Mass Storage Device
7 When USB driver is not Installed automatically, refer to next page.
Note :
For WinXP, the following window will appear whenever you connect the USB cable to your yepp.
14 | 15 |