Haier FCD-JTHC50-E user manual Dimensions, Electric Circuit Diagram, Operation Instructions, Model

Dimensions

(Fig. 1)

Front View					Cutaway View				Bottom View
		a1			d1
					E	E
			b1	D	f1	C			e1
	A	B			C1
Model		Net	a1	b1	c1	d1	e1	f1	A Hot water outlet
	Volume Weight
									B Cold water inlet
									C Heating element
									D Enamel tank
									E Wall-mounting bracket
Remarks:the permitted error limit of above parameters is								10%.

Electric Circuit Diagram

	MT	BT
L		EH
N	E	HL
L: Brown wire
N: Blue wire		E
MT:High temperature limiter
BT: Thermostat
HL: Heating indicator
EH: Heating element
E:Yellow/green wire

Operation Instructions

For the first use after installation, due to there's no water within the tank, first the city water inlet valve and any water outlet valve of the water heater must be opened. Close the water outlet valve when water flows out continuously from the showerhead or other outlets (the tank is full). Check connections are free of water leakage, and insert the power plug.

Turn the knob to set your desired water heating temperature, which can be stepless changed between cold water inlet temperature and 75 . In heating mode, heating lamp is lighted on. Normally the knob shall be positioned at highest temperature. This machine has a thermostat function, which automatically switches off the water heater when temperature reaches the setting value, and switch on again when water temperature decreases to certain value.

City water pressure 0.75 MPa will cause much water flowing out from safety valve pressure relief vent. This is due to too big water pressure. Please ask after-sales service for correction.

Attentions in Operation

1.To avoid causing machine troubles, do not connect power before tank is full of water.

2.Adjust a suitable temperature before use, for water temperature above 50 may burn your skin.

3.This product is closed water heater, which can supply hot water through pipe connection to several points like bathroom (bathtub, washbasin, showerhead) and kitchen.

4.Heating adjustment can be made flexibly all year round adapting to climate changes. In long-term out-of-use or maintenance, you can close city water pipe valve, open mixing valve, and move up safety valve handle to drain the tank. To avoid injury, before next use, it is suggested to first open hot water valve before switching on the water heater, exhausting gas possibly retained in the pipeline. In this case, no smoke or fire is permitted near the open valve. Carefully check and confirm all parts are in good condition.

5.Provided hot water quantity can meet use demand, temperature setting shall be possibly low. It can minimize heat dissipation, high-temperature corrosion and sedimentation, ensuring a longer service life.

6.Regularly ask servicemen to make safety inspection, remove sediment on heating elements, and check consumption of anode bar. Too much consumed anode bar shall be replaced.

Cleaning and Maintenance

Statement: This water heater shall only be repaired and maintained by qualified servicemen. Improper maintenance may cause severe injury or damage. Before opening or repairing water heater, please do pull out the power plug.

Note:Before asking for service, please refer to troubleshooting section to resolve easy problems.

External Cleaning: Disconnect power supply before cleaning. Gently wipe with wet cloth dipped with a little of mild detergent. Do not use gasoline or other solvents. Finally dry with dry cloth. Keep water heater dry. Do not use cleansers containing grinding agent (e.g. toothpaste), acids, chemical solvents (e.g. alcohol) or polishers to clean.