Haier FCD-JTHA40-III, FCD-JTHA50-III, FCD-JTHA60-III user manual Parameters, Dimensions

Parameters

Rated voltage: 220V~,50Hz	Dimension: (See to Figure 1)
Power: 1500W	Weight: (See to Figure 1)
Rated pressure: 0.65 / 0.75MPa	Volume: (See to Figure 1)
Waterproof grade: IPX 4 ( )	Tap water pressure: no less than 0.05MPa

Dimensions

(Figure 1)

Front view	Cutaway view	Bottom view
a1	d1

Operation Instructions

For the first use after installation, due to there's no water within the tank, first the city water inlet valve and mixing valve must be opened. Close the mixing valve when water flows out continuously from the showerhead or other outlets (the tank is full). Check connections are free of water leakage, and insert the power plug.

Turn the knob to set your desired water heating temperature, which can be stepless changed between cold water inlet temperature and 75 . In heating mode, heating lamp is lighted on. Normally the knob shall be positioned at highest temperature. This machine has a thermostat function, which automatically switches off the water heater when temperature reaches the setting value, and switch on again when water temperature decreases to certain value.

City water pressure 0.75 MPa will cause much water flowing out from safety valve

E

b1

D

A B

C

f1

E

C1

e1

pressure relief vent. This is due to too high water pressure. Please ask after-sales service for correction. The rated pressure of FCD-JTHA40-(E) is 0.65 MPa

Attentions in Operation

Model		Volume	Net	a1	b1	c1	d1	e1	f1
			weight
FCD-		40L	18.5kg	673mm	391mm	100mm	220mm	365mm 197mm
JTHA40-	(E)
FCD-		50L	20kg	702 mm	444 mm	100 mm	235 mm	390 mm 197 mm
JTHA50-	(E)
FCD-		60L	22.8kg	802 mm	444 mm	100 mm	335 mm	390 mm 197mm
JTHA60-	(E)

A Hot water outlet B Cold water inlet C Heating element D Enamel tank

EWall-mounting bracket

1.	To avoid causing machine troubles, do not connect power before tank is full of water.
2.	Adjust a suitable temperature before use, for water temperature above 50 may burn
	your skin.
3.	This product is closed water heater, which can supply hot water through pipe
	connection to several points like bathroom (bathtub, washbasin, showerhead) and
	kitchen.
4.	Heating adjustment can be made flexibly all year round adapting to climate changes. In

Remarks:the permitted error limit of above parameters is 10%.

Electric Circuit Diagram

long-term out-of-use or maintenance, you can close city water pipe valve, open mixing

valve to hot water range, and move up safety valve handle to drain the tank. To avoid

injury, before next use, it is suggested to first open hot water valve before switching on

the water heater, exhausting gas possibly retained in the pipeline. In this case, no

smoke or fire is permitted near the open valve. Carefully check and confirm all parts are

in good condition.

L:Brown wire

N:Blue wire

MT: High temperature limiter

BT: Thermostat	L
HL:Heating indicator
EH:Heating element
E:Yellow/green wire	N

MT

E

BT

HL

EH

E

5. Provided hot water quantity can meet use demand, temperature setting shall be

possibly low. It can minimize heat dissipation, high-temperature corrosion and

sedimentation, ensuring a longer service life.

6. Regularly ask servicemen to make safety inspection, remove sediment on heating

elements, and check consumption of anode bar. Too much consumed anode bar shall

be replaced.

3