Bogen 700286198 Speaker Installation, Speaker Grille Removal, Speaker Grille Installation

Page 4

Speaker Installation

If the power level is known, then select it using the front-mounted selector switch prior to installing the speaker. See section Selecting Power Levels.

Speaker Grille Removal

Insert a pocket knife blade between the grille and the bezel about a 1/4" deep and then gently pry the grille upwards. Do this in multiple places around the circum- ference of the grille to free the grille.

Speaker Grille Installation

The speaker grilles fit tightly! Make sure the tap set- tings are correct prior to installing grille. Push the speaker grille in until it can go no further. Then, slap around the edge of the grille to seat the grille. The grille is properly seated when it is flush with the edge of the bezel.

Suspension Cable Assembly

1. Screw nuts onto the eye bolts all the way to the flange.

2.Screw in eye bolts with captured cable sec- tions in to the three suspension points. Do not overtighten.

3.Snap loops of free end of cable sections into quick-snap clip.

4.Connect quick-snap clip to drop cable. The supplied cable kit is suitable for use as the drop cable.

Safety Cable

1.

3.

2. 4.

The speaker includes a safety cable suspension point for extra protection. The included cable kit must be used as a safety cable. Refer to instruc- tions with cable kits for proper use.

IMPORTANT

The anchor point and any hardware used to anchor the speaker must be able to support the speaker’s weight under all conditions. IF YOU ARE NOT SURE OF THE PROPER CAPACITY OF THESE ITEMS TO USE, CONSULT A STRUCTUR- AL ENGINEER. Mount only one speaker per supplied quick-snap clip.

2

Image 4
Contents Pendant Speaker Product Description Product Diagrams Front DrawingSpeaker Installation Speaker Grille InstallationSuspension Cable Assembly Safety CableDaisy Chaining Speaker WiringSpeaker Phasing 70V/100V Systems Selecting Power Levels16Ω Systems Specifications Specifications