FULL FLUSH MOUNTING
Step 1: Determine where the tweeter will be mounted. Make sure there is a flat area large enough for the tweeter and no obstructions behind the area.
Step 2: Using supplied template mark with a pen the hole needed for the tweeter.
Step 3: Be sure the hole is large enough for the tweeter housing.
Step 4: Cut the | hole for the tweeter. When using factory locations, this |
step can | be skipped. A hole can be cut either with a pair of metal tin |
snips or a 2" hole saw for soft materials or
WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill.
Step 5: Install tweeter in flush mount housing.
Step 6: Connect the speaker wires observing the correct polarity.
Step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat with the front of the surface.
Step 8: Use the supplied pressure ring to secure the housing to the surface.
SURFACE | MOUNTING |
| SURFACE | ||
MOUNT | SCREWS |
|
| MOUNT | |
TRIM RING |
|
|
| HOUSING | |
|
|
|
|
|
|
|
|
|
|
|
|
PRESSURE RING
TWEETER
| TWEETER WIRE | PANEL |
|
|
| ||
|
|
WIRING HARNESS
© 2007 directed