Installing the Crossover

Step 1: Find a location for the crossover away from any factory or after market electrical wires. It is recommended to mount the passive crossover close to the amplifier. In the event you decide to upgrade and bi-amplify the system, mounting the passive crossover close to the amplifier would simplify the installation upgrade.

Step 2: Remove top cover of crossover housing. Don’t lose it.

Step 3: Mark with a marking pen the two mounting holes.

Step 4: Remove crossover and pre-drill mounting holes using a 1/8” drill bit.

WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill.

Step 5: Mount the crossover using the supplied #8 screws.

Step 6: Connect the wires. Make sure the speaker wires for the mid/woofer go to the

woofer	output	and	the	tweeter	to	the	tweeter	output.
Be sure	to	observe	the	correct	polarity.		Changing the
polarity of the tweeter may be necessary					for	optimum sound		quality.

Step 7: Re-install the crossover cover.