BACK PANEL DIAGRAM
1This switch uses the internal matching transformer to select the impedance of your Ardent™ 15M. It does not affect speakers plugged into jacks (cd). NOTE: The speaker acoustical output will drop 3dB when switched to 16 ohms. This is because the load on the amplifier driving the Ardent™ 15M is ½ that of the 8 ohm setting.
2This
3These 1/4” jacks are used to connect the speaker cabinet to an amplifier, such as a powered mixer or power amp. These jacks are wired in parallel, so they can be used to connect to another speaker cabinet.
4This jack accepts Neutrik Speakon® connector. Pins +1 and - 1 are used. This jack is also wired in parallel with the 1/4” jacks (c).
Block Diagram
Horn
SpeakondJacks
+1 |
1/4” Jacks
8 - 16 Ohm
Selector
Attenuator
Impedance | transformer |
Horn
Protection
Speaker
Crossover
+
-
4