Hollywood 24CX-2, 24CX-3, 24CX-4 owner manual Read Before Using

Page 2

IMPORTANT!

*** Read Before Using ***

CAUTION: The following must be observed to prevent malfunctioning and/or possible equipment damage.

Before plugging the unit into the main AC line, make sure that all of the equipment following the crossover output lines is turned off or all of the inputs are turned down.

Never change the frequency range switch from the x10 to x1 position (or vice versa) with the crossover output levels passing signal. Transients can result and speaker damage is possible.

The unit should be plugged in only when it has been established that the main AC line is supplying the correct voltage and frequency. US models are set up for 110 VAC at 60 Hz.

Keep the unit away from excessive moisture.

Allow only authorized technicians (consult your dealer) to open the unit. TDM Audio assumes no liability for damage or injuries.

© 2003 TDM Audio, Inc.

Electronic Crossover Owner’s Manual

Page 2

Image 2
Contents TDM Read Before Using Table of Contents Introduction Crossover FundamentalsSignal Source Power Amplifier Passive Crossover Shows a typical active crossover configuration Crossover TerminologyHow Crossovers Work Filter Frequency Response Curve24 dB per Octave Filter Curve Three-Way Crossover Response Using the Security Cover Mounting the Unit in a RackMaking Adapter Cables Hooking Up the CrossoverWhat You’ll Need Three-Way Operation 24CX-2 or 24CX-4 Basic Hook-UpTwo-Way Operation 24CX-2 or 24CX-4 Three-Way Operation 24CX-3 Four-Way or Five-Way Operation 24CX-4Operating the Crossover Front Panel ControlsAdjusting the Crossover Frequencies Three-Way Control MeaningsUsing the CD Horn Boost Checking the HookupAdjusting the Output Levels Adjusting the Input LevelsTDM Option Cards Optional Output Limiters Distortion Troubleshooting and SupportNo Signal Output Excessive Noise Hertz Hum or BuzzContacting TDM Specifications 24CX-2, 24CX-4