Specifications
Model GP7170-4000
| U.S | Metric |
Volume | 84.5 GPM | 320 LPM |
Discharge Pressure | 1450 PSI | 100 bar |
Speed | Up to 700 RPM | |
Inlet Pressure | Up to 90 PSI2 (10 bar) | |
Plunger Diameter | 2.48” | 63 mm |
Plunger Stroke | 2.05” | 52mm |
Crankshaft Diameter | 2.05” | 52mm |
Key Width | 14mm | |
Crankshaft Mounting | Either side | |
Shaft Rotation | Top of pulley towards manifold | |
Temperature of Pumped Fluids | 140 oF | 60oC |
Inlet Ports | (2) 1 1/4" NPT | |
Discharge Ports | (2) 3/4" NPT | |
Weight | 374 lbs | 170 kg |
Crankcase Oil Capacity | 1.6 Gal | 6.0 liters |
Fluid End Material | Stainless Steel | |
Consult the factory for special requirements that must be met if the pump is to operate beyond one or more of the limits specified above.
GP7170 PULLEY SELECTION & HORSEPOWER
REQUIREMENTS
PUMP | MOTOR | RPM | GPM | 500 PSI | 750 PSI | 1000 PSI | 1500 PSI |
PULLEY | PULLEY | ||||||
12.75 | 7.00 | 300 | 36.0 | 12.9 | 19.3 | 25.7 | 38.6 |
12.75 | 9.20 | 400 | 49.0 | 17.5 | 26.3 | 35.0 | 52.5 |
12.75 | 11.45 | 500 | 60.0 | 21.4 | 32.1 | 42.9 | 64.3 |
12.75 | 12.75 | 700 | 84.5 | 30.2 | 45.3 | 60.4 | 90.5 |
HORSEPOWER RATINGS: | We recommend a 1.1 service factor be specified |
| when selecting an electric motor as the power |
The rating shown are the power require- | source. |
ments for the pump. Gas engine power |
|
outputs must be approximately twice the | To compute specific pump horsepower requirements, |
pump power requirements shown above. | use the following formula: |
| GPM X PSI |
1400 | = hp |
|
3