Niles Audio SVL-2 manual Tube Amplifier Using a

S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M

near electrical devices, route the speaker wires several feet away from the electrical wiring.

Using the SVL-2 with Tube-Type Amplifiers

Virtually all tube amplifiers must have a load connected at all times. If the amplifier to be connected to the SVL-2 is a tube amplifier, be sure to always have at least one pair of speakers switched on at all times. An alternative is to permanently connect a 150 ohm, 5 watt resistor across the tube amplifier's output in parallel with the SVL-2. See (Figure 1) for hookup diagram.

Tube Amplifier

Figure 1

Using a

Tube Amplifier

6