HeadsetUSA manual FreePORT PAS 400 Version

Page 4

yAlways check before connecting the power cable to the mains socket that the power switch on the unit itself is set to off ("O").

yUse the power cable or power supply that came with the unit to connect to the mains socket (wall outlet).

yPower supply: a damaged power cable may not be repaired. Use a new cable.

yAvoid plugging the mains cable into a power strip that already has several other power- consuming devices connected to it.

yAvoid using extension cables. The unit must be connected to a mains socket close to it, and that socket should be freely accessible.

Installation: y This product may only be placed on a stable, clean, horizontal surface.

yDo not expose this product to vibration.

yDo not operate this product anywhere near water or other liquids. Do not use it near a sink, swimming pool, bathtub, or in any damp room or area. Electrical shocks carried through water can kill. Do not place any beverages whatsoever on or near this product, as liquids can kill electronic components.

yEnsure sufficient ventilation around the product to allow for adequate heat dissipation, especially near the rear panel and the sides of the cabinet (minimum of 8 inches from the nearest wall). The unit may only be installed in a rack if measures are taken to ensure sufficient ventilation and if the mounting instructions of the manufacturer are followed. Do not block or cover any heat sink, fan, or vent.

yDo not place the product where it will be in the path of direct sunlight, and keep it a safe distance away from radiators and other heaters of any kind.

yIf you bring this product from a cold environment into a warm one (such as from a vehicle into a studio), it is quite possible that condensation will form inside the cabinet. Please allow the unit sufficient time for acclimation to room temperature (minimum thirty minutes) before connecting and powering up.

yTo avoid accidents, do not use any accessory equipment with this product that is not approved by the manufacturer, particularly mounting accessories.

yDo not place this unit on any unstable platform, cart, stand or table. If the unit falls, it can cause bodily injury to persons, or can be damaged itself.

yTo protect this product from lightning damage during a thunderstorm or from power surges during an extended absence, disconnect the power cable from the wall outlet.

4 freePORT PAS 400 Version 060328

Image 4
Contents Portable active loudspeaker freePORT Content Safety Instructions FreePORT PAS 400 Version FreePORT PAS Rear Panel ViewInstallation & Set-up Safety PrecautionsDeliverables Operating ConditionsSet Up Power / Mains ConnectionTripod or Pole Mounting Wall or Ceiling MountingGround Lift Switch Powering with a 12-16 Volt DC External or Auto BatteryPower Switch Fuses 3Battery Charging Circuit & Loading Indicator Power On IndicatorBattery Self-Discharge During Storage, at 77 F 25 C Connecting Signal Sources Deep Discharge Cut-Off CircuitInput 1 Input 2Input 3 RF Receiver InputPDD 63 Delay Unit Audio and DC OutputsLine OUT REC OUTOperation Battery Replacement and Disposal Rechargeable Battery -DescriptionTone Controls Troubleshooting Problem Possible Cause Possible SolutionsPerformance Curves Product Specifications InputsInput RF-RECEIVER Input FreePORT PAS 400 Version 060328 Warranty Information