Genelec Using the 8240A and 8250A in STAND-ALONE Mode, Connections, Mains Input connector

Page 5

USING THE 8240A AND 8250A IN STAND-ALONE MODE

The 8240A and 8250A accept both analogue line level input signals and AES/EBU formatted digital input signals.

When the 8240A and 8250A are not connected to Genelec loudspeaker control network, they operate in the stand-alone mode. However, settings made with the Genelec Loudspeaker Manager software can be saved into each loudspeaker and applied even when the network is disconnected by setting switch 1 “STORED/MANUAL CONTROL” on switch group 2 of each loudspeaker to position “STORED.”

This manual concentrates on using the 8240A and 8250A without the control network. All issues concerning use with the network are explained in detail in the System Operating Manual provided with the GLM™ Loudspeaker Manager software kit.

Connections

Each loudspeaker is supplied with a mains cable, one 5 m GLM network cable and an operating manual. Before connecting up, ensure that the mains switch is off.

“MAINS INPUT” connector

Connect the mains supply to this connector.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Dsp Page Compliance to FCC Rules IntroductionEC Declaration Of Conformity Amplifiers SystemDrivers Connections Using the 8240A and 8250A in STAND-ALONE ModeMains Input connector Digital Thru AES/EBU connector Digital in AES/EBU connectorAnalog in connector Control Network connectorsAlign the loudspeakers correctly Mounting ConsiderationsMaintain symmetry Minimise reflectionsFunctions on switch group 1 Tone controls Setting the input sensitivityTreble Tilt control Stored / Manual Ctrl Functions on Switch GroupDriver Mute System LvlSafety considerations Maintenance8250A Accessories Guarantee8240A Accessories 8240A 8250A Specifications8240A 8250A
Top Page Image Contents