Fortinet DS35, 05DS525, 05DS693 manual Optional

Page 7

Installation

If custom door mounting locations for the DS-Series Coax Speakers are desired, be careful to avoid interference from the window and door lock mechanisms. The first step is to find a location on the door panel that will accept the dimensions of the speaker. Then remove the door panel from the door, and check for operational clearance of the window. Cycle the window all the way down and up. If metal must be cut to mount the speakers, avoid structural metal and braces. An optional reinforcing panel (thin piece of wood or Medium Density Fiberboard) may be necessary if the door panel cannot support the weight of the speaker. Mount the speaker to the door panel and door body as outlined in Figure 1.

If the factory door speaker wiring is not available, it will be necessary to run the supplied wire through the door jamb. The speaker wire should be kept away from sharp edges and avoid the possibility of getting pinched by the door. An existing grommet in the door jamb is the ideal place to run the speaker wire. If the factory hole and grommet do not exist or are inaccessible, you must drill a hole to run the speaker wire through the door jam. Be careful not to drill into other wiring or existing door mechanisms. Any time a wire is run through a hole, it is necessary to insert a rubber or plastic grommet to protect the wire from damage as outlined in Figure 2.

Installation

Figure 1

Figure 2

(Optional)

Stagger Holes

For Wiring &

Use Grommets (When Factory Holes and Grommets are not Available)

To Crossover

Screw Grill on with the provided Hardware

DS-Series Coax Speakers

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Page Authorized Kicker Dealer Purchase Date Speaker Model Number Models DS35 / DS40 / DS46 / DS525 / DS60 / DS68 / DS693Features Performance Grills Included Yes Mounting InstallationOptional Wiring Wiring OptionsWiring two DS-Series Coax Speakers to a single channel Warranty Tech Lines
Top Page Image Contents