Panasonic PV-D4743S Before doing Initial Setup, Doing Initial Setup Ready to Play, Turn TV on

Initial Setup for Basic Connections (Ready to Play)

Before doing Initial Setup

1 Turn TV on.

2 See connections a RF Coaxial Cable Connection and b AV Cable Connection on p. 12.

<RF Coaxial Cable Connection> Set TV to channel 3.

<AV Cable Connection> Set TV to VIDEO.

3 [DECK ➛ TV]

• Go to “Doing Initial Setup (Ready to Play).” (See below.)

[Cable Box ➛ DECK ➛ TV], [DSS ➛ DECK ➛ TV]

•Turn on Cable Box and set it to your Public Broadcasting Station (PBS) channel in your time zone.

•If you use a DSS Receiver, it must be turned off.

Doing Initial Setup (Ready to Play)

1

2

Press VCR on remote for VCR mode.

Plug DECK Power Cord into AC wall outlet. DECK comes on and auto channel and clock set starts.

•If screen below does not appear, check DECK - TV connection and, if TV is tuned to channel 3, try switching it to channel 4.

•To change VCR’s output channel, please refer to “VCR’s Output Channel” on p. 19.

CH AUTO SET PROCEEDING

CANCEL : STOP

AUTO CLOCK SET

PROCEEDING

Plugging the AC Power Plug into an AC outlet

Notes

•Function buttons are inoperative during Initial Setup.

•To remove a cassette during Auto Set, press EJECT on the remote or STOP/EJECT twice on the DECK.

In this case, settings must be made manually. (See p. 18.)

•Depending on conditions, Auto Clock Set may take longer than 30 minutes. If so, press STOP to stop setup and perform settings manually. (See p. 18.)

CANCEL : STOP

Continued on next page...

16 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com