Tip
You can have the player go on the next day at the same time. Just press STANDBY until the t indication appears in the display. The preset settings remain until you reset them.
Note
“TIMER” disappears from the display and the timer mode is canceled:
–when you press 9 button of the tape player while music plays in the timer mode.
–when you select “TAPE” using FUNCTION on the remote.
7 Press STANDBY.
The tindication lights up and the power goes off.
At the preset time, the power will go on, “TIMER” appears on the display and music will play, and will shut off automatically after about 60 minutes.
To check/change when the playback will start
Press CLOCK/TIMER, then DISPLAY/ENTER. Each time you press DISPLAY/ENTER, a stored setting lights up. Change the setting if you need to when the setting lights up. When you finish checking, press CLOCK/TIMER again.
To use the player before a timer playback starts
Just turn on the player, and then you can use it.
If you turn off the player before the preset time, timer playback will start at the preset time.
In case of the radio, however, if you listen to the station which is different from the one you tuned in in step 1 on page 20, you will hear that station at the preset time. Make sure to tune in the station you want to listen to before you turn off the player.
To stop play
Press POWER.
The Timer
The Timer