UNDER CABINET INSTALLATION
Cabinet or Shelf
Spacers | 3/4 or less |
| Spacers |
|
| ||
|
|
|
|
FRONT VIEW |
| SIDE VIEW |
1)Choose an appropriate mounting location underneath a cabinet or shelf. Close pro- ximity to an electrical outlet, TV antenna or cable connection will facilitate a neat, easy installation. Do not mount the VE720E/VE920E above a range or oven. Be sure that the location chosen will provide adequate access to the electrical connections on the rear of the unit before continuing.
2)If the location chosen has a bottom edge molding it may be necessary to use the mounting spacers provided to effectively lower the VE720E/VE920E below or even with the molding. Measure the distance between the edge molding and the bottom of the cabinet. The spacers and mounting holes are stepped to achieve different moun- ting heights from 5” to 1”. Adjusting the mounting height is done by lifting and rota- ting the spacer in the mounting hole. Choose a spacer height, which will allow the VE720E/VE920E to clear the edge molding.
3)Measure the thickness of the bottom of the cabinet or shelf and the spacer height cho- sen. Select the shortest screw length, which will secure the VE720E/VE920E to the bot- tom of the cabinet.
4)Cut out the template supplied and tape it in place onto the cabinet surface to be dril-
led. Center punch the four holes indicated on the template and remove the template.
5)Carefully drill four 1/8” holes at the locations marked above.
6)Connect your TV antenna or cable system to the antenna connector on the rear of the VE720E/VE920E.
7)Attach the FM Dipole Antenna and position the antenna for the best reception.
8)Attach the AM Antenna and position the antenna for the best reception.
9)Position the VE720E/VE920E and mount it in place using the selected screws. NOTE: Do not
10)Plug the AC power cable into the wall outlet. Route the wires safely away from heat and moisture sources.
51