Jensen JIMS-125I user manual Listening to Radio, Snooze Function, Hints for Best Reception

Page 10





The iPod / iPhone alarm will sound for 60 minutes and then turn off automatically if no snooze button pressed.

To stop the iPod / iPhone sound immediately, tap the button.

Snooze Function

 When the alarm sounds, it can be temporarily stopped by pressing the SNOOZE button. The display will show the relative alarm indicator or flashing.

 The alarm will be delayed for 9 minutes and then come again.

 This manual snooze operation can be repeated again within one hour.

LISTENING TO RADIO

1.Press the POWER button to turn on the unit.

2.Press the FUNCTION button to select Radio mode.

3.To manually tune the radio station, press the or button repeatedly. Use the manual tuning method to tune to weaker stations that are bypassed during Automatic Tuning.

4.To automatically tune to the next radio station with the strongest signal, press and hold the or button for 1-2 seconds until frequency readout on the display begins to scan and then release the button. The tuner will stop scanning when it receives the next strongest station signal.

5.Adjust the volume control to the desired volume level.

HINTS FOR BEST RECEPTION:

The receiver has a build-in FM wire antenna hanging from the back cabinet. This wire should be totally unraveled and extended for the best reception.

NOTE: Automatic tuning depends on the signal strength of the broadcasting station, so weak stations may be skipped. You can manually tune to find the weak stations if a station gets skipped. With strong signals, the tuner may stop before it reaches the actual broadcast frequency, so you may need to manually tune for the best reception.

PRESET RADIO STATIONS

This unit has 20 preset memories for the FM radio.

1.Press the POWER button to turn on the unit.

2.Press the FUNCTION button to select Radio mode.

3.Tune to the desired radio station either by “manually” or “automatically” tuning method.

4.Press and hold the MEM.SET/CLK.ADJ. button to enable the program function and

3

Image 10
Contents JiMS-125i Dear Jensen Customer To establish a safe levelImportant Safety Instructions Important Notes Compliance with FCCProtect Your Furniture Location of Controls To SET the Time Using iPhone / iPod Time Sync Clock SettingClock Back-up Battery Installation Getting StartedTips Alarm SettingTo SET the Time Manually Wake to Radio Wake to Beep AlarmWake to iPod / iPhone Snooze Function Preset Radio StationsListening to Radio Hints for Best ReceptionInserting the iPod Bracket Recalling Preset Memory ChannelsIPod Bracket PlaybackAuxiliary Input Sleep Timer OperationsDimmer ChargingCare and Maintenance ResettingCleaning the Unit Troubleshooting Guide Power requirement SpecificationFrequency Range DAY Limited Warranty and Service Valid in the U.S.A only