Jensen JIMS-125I user manual Resetting, Care and Maintenance, Cleaning the Unit

Page 13





3.Turn on the external audio device.

4.To select auxiliary audio input, press the FUNCTION button to select AUX mode.

5.The volume level can now be controlled through the main unit. Operate all other functions on the auxiliary device as usual.

NOTE:

 If you connect this unit to the Line-Out Jack of your external device then you only need to adjust the volume control of this unit. If you connected the Headphone Jack of your external device then you may need to adjust both the volume control of your external device and the volume control of this unit to find the most desirable volume setting.

 Press the POWER button to turning off the unit when you finish listening. Don't forget to switch off the power of your external device as well.

RESETTING

If the system does not respond or exhibits erratic or intermittent operation, you may have experienced an electrostatic discharge (ESD) or a power surge that triggered the internal microcontroller to shut down automatically. If this occurs, simply disconnect the AC adaptor and remove the system backup battery, wait for at least 3 minutes and then setup the unit again as if it is a brand new unit.

CARE AND MAINTENANCE

1.Do not subject the unit to excessive force, shock, dust or extreme temperature.

2.Do not tamper the internal components of the unit.

3.Clean your unit with a dry cloth. Solvent or detergent should never be used.

4.Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.

5.Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors.

CLEANING THE UNIT

To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.

The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use caution when cleaning and wiping the plastic parts.

If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish sprays on the cabinet.

If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or polishes as these will damage the finish of your unit.

CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.

6

Image 13
Contents JiMS-125i To establish a safe level Dear Jensen CustomerImportant Safety Instructions Compliance with FCC Important NotesProtect Your Furniture Location of Controls Clock Back-up Battery Installation Clock SettingTo SET the Time Using iPhone / iPod Time Sync Getting StartedTips Alarm SettingTo SET the Time Manually Wake to Radio Wake to Beep AlarmWake to iPod / iPhone Listening to Radio Preset Radio StationsSnooze Function Hints for Best ReceptionIPod Bracket Recalling Preset Memory ChannelsInserting the iPod Bracket PlaybackDimmer Sleep Timer OperationsAuxiliary Input ChargingCare and Maintenance ResettingCleaning the Unit Troubleshooting Guide Power requirement SpecificationFrequency Range DAY Limited Warranty and Service Valid in the U.S.A only