Jensen JiMS-60 Power Source, Battery BACK-UP System, Battery Installation, Dimmer Control

Page 6

POWER SOURCE

This unit is designed to operate on normal household AC power rated at 120V/60Hz. Operating this unit from any other power source may cause damage to the unit, and such damage is not covered by your warranty.

It is also equipped with a battery back-up system for the clock that is powered by an optional 9V 006P battery (type 6F22 or equivalent – not included).

BATTERY BACK–UP SYSTEM

The Battery Back-up System ensures the clock and alarm settings will be retained during a power interruption or power outage (in order to preserve the battery life the Display will not light). All clock settings will be kept in memory, however, the clock time may require adjustment for exact accuracy once the power returns. If a battery is not installed, the Display will blink”12:00” when the power is restored. This will indicate that you have to reset the time and alarm settings.

BATTERY INSTALLATION

1.Open the battery compartment door on the bottom of the cabinet and connect a 9V DC battery to the Battery Clip located inside.

Note: The battery clip only fits one way to ensure the correct polarity.

2.Replace the Battery Compartment Door. IMPORTANT: Be sure that the battery is

installed correctly. Wrong polarity may damage the unit.

3.For optimum performance, an alkaline-type battery is recommended. If the unit is not to be used for an extended period of time, remove the battery. An old or leaking battery can cause damage to the unit and will void the warranty.

4.Do not try to recharge batteries that are not intended to be recharged; they can overheat, rupture and leak. (Follow the battery manufacturer’s directions).

5.Do not dispose of batteries in fire, batteries may leak or explode.

DIMMER CONTROL

Slide the DIMMER switch on rear panel to High/Low position to control the display brightness.

POWER FAILURE INDICATOR

If there is no battery installed in the unit or the battery installed is weak or dead, the time and alarm settings will be lost if the power is interrupted. When the AC power is restored the display will flash “12:00”. This indicates that the time displayed is incorrect and needs to be reset.

IMPORTANT:

After you reset the time, be sure to reset your alarm settings as well.

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Docking Music System for iPOD We Want You Listening For a Lifetime Dear Jensen CustomerTo establish a safe level Customers RecordImportant Safety Instructions Important Notes Compliance with FCC Regulations Protect Your FurnitureBattery Installation Power SourceBattery BACK-UP System Power Failure IndicatorLocation of Controls and Indicators Clock Settings Radio OperationsTips for Best Radio Reception Alarm Operations Setting the Wake UP TimeIPod playback control Wake to Alarm Checking the Wake UP TimeWake to Radio Sleep to Music Sleep Timer OperationsSnooze Alarm Sleep and Wake to MusicResetting Care and MaintenanceAuxiliary Input Troubleshooting Guide Symptom Possible Problem SolutionSpecifications Power RequirementFrequency Range DAY Limited Warranty and Service Valid in the U.S.A only
Top Page Image Contents