2. CLEANING OF FRONT PANEL
•Remove the front panel and wash with clean water. Wash it with a soft sponge. After using neutral detergent, wash thoroughly with clean water.
• When front panel is not removed, wipe it with a soft dry cloth. Wipe the remote controller thoroughly with a soft dry cloth.
•Wipe the water thoroughly.
If water remains at indicators or signal receiver of indoor unit, it causes trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands to detach and attach it.
Removing the Front Panel | Removing the Front Panel |
Shaft
| Hole | Step |
|
| |
• When the front panel is fully opened with both | • When the front panel is fully opened with both | |
hands, push the right arm to the inside to release | hands, push the right arm to the inside to release | |
it, and while closing the front panel slightly, put | it, and while closing the front panel slightly, put | |
it out forward. | it out forward. |
|
|
|
|
|
|
|
| CAUTION |
|
|
|
|
|
|
|
|
|
|
• Do not splash or direct water to the body of the unit when cleaning it as |
| A |
| ||
| this may cause short circuit. | BENZINE | C | TH INNER | |
| I | ||||
• Never use hot water (above 40°C), benzine, gasoline, acid, thinner or a |
| D |
| ||
|
|
| |||
| brush, because they will damage the plastic surface and the coating. |
|
|
| |
|
|
|
|
|
|
3. MAINTENANCE AT BEGINNING OF LONG OFF PERIOD
• Run the unit by setting the operation mode to (FAN) and the fan speed to HI for about half a day on a fine day, and dry the whole of the unit.
• Switch off the power plug or turn off the circuit breaker.
Air
Blow
– 17 –
РУССКИЙ ∂ÏÏËÓÈο PORTUGUÊS SPANISH ITALIANO FRANÇAIS DEUTSCH ENGLISH