DV2007
10.TUNER OPERATION
7)BAND BUTTON (BAND)
Press BAND to change between three FM bands and two AM bands.
20&21)TUNING UP/DOWN BUTTON ( 
/ 
)
Manual Tuning
Press the Up Tuning(
) or Down Tuning ( 
)button for more than 3 seconds to move the radio frequency number up or down by one step.
Auto Seek Tuning
Press the Up Tuning ( 
)or Down Tuning ( 
)button for less than 3 seconds to move to
next station automatically.
12~17)PRESET STATIONS BUTTONS
Six numbered preset buttons store and recall stations for each band.
11)AUTOMATICALLY STORE / PRESET SCAN (AS/PS)
Automatically select 6 strong stations and store them in the current band. Select a band (if needed). Press AS/PS button for more than three seconds. The new stations replace stations already stored in that band.
Preset Scan
Scan stations stored in the current band. Select a band (if needed). Press AS/PS button for less than 3 seconds. The unit will pause for ten seconds at each preset station. Press AS/PS button again to stop scanning when the desired station is reached.
STEREO
11. iPod OPERATION
This unit is equipped with iPod Ready function which allow end user to have direct control of the iPod on the front panel control button and display iPod song information on the unit's LCD display. Pls read below for more details operation
iPod Compatibility Chart
This unit is support following iPod software version
iPod 1G | Not Supported |
iPod 2G | Not Supported |
iPod 3G | Firmware Version 2.2 |
iPod Mini | All versions |
iPod 4G | All versions |
iPod Photo | All versions |
iPod Nano | All versions |
iPod 5G(Video) | All versions |
Connect the iPod to this unit
8 Din iPod Ready Cable
HEAD UNIT
iPod | iPod | iPod | iPod | iPod |
Video | photo |
| mini | nano |
The unit will automatically pick up a stereo signal when available. When in stereo mode, the ST icon appears in the display. When no stereo signal is available, the unit will automatically revert to mono operation, and no icon will be displayed.
About Video File
iPod Cable
This unit can support iPod Video display output feature, however it is NOT ABLE to select any VIDEO FILE OR VIDEO ALBUM which contained in the iPod Video. This unit will only automatically select Music Album or File regardless the connected Video iPod last playing is a Video File or Album. If user want to select and playback a video file on the iPod Video, Long press “AS/PS”button for more than 3 seconds to
Turning iPod Power On and Off
The iPod power turns on automatically as soon as it is connected to the 30 Pin Connector and as long as the vehicle's ignition is turned ON. The iPod power can be turned OFF by removing the iPod from the 30 Pin Connector or if the vehicle's ignition is turned OFF. Under this condition the iPod will go into pause mode and goes into sleep mode about 2 minutes later
While the iPod is connected, the power cannot be turned on or off from the iPod itself.
Tips “ |
| ” will be shown in the iPod's display while it is connected to the unit . |
| OK to disconnect |
|
|
|
|
iPod Battery Charging
While connected to the unit, the iPod will automatically start
9