NOTE: If the air filter is used when wet, suction is impaired and the motor may be damaged.
HYGIENIC AIR FILTER (for CV-S890, Fig. 20)
Periodically check the condition of the exhaust air filter. To replace it:
1.Remove the bag compartment lid å.
2.Pull out the filter by its top tab and discard it í.
3.Push in a new filter ì.
4.Close the bag compartment lid å.
HOW TO MAINTAIN CLEANING
EFFICIENCY AND AVOID ACCIDENTS
●The plug of the power supply cord should be removed from the socket outlet before cleaning the appliance or
●If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
●Be sure to replace a new cloth bag after disposing of the full one. There is a device which prevents the bag compartment lid from being closed when the cloth bag has not been replaced. Do not tamper with this to use without bags as dust will be sucked directly into the mechanical parts and may damage the motor.
●Do not use the cleaner to pick up wet dirt, and avoid using the cleaner in a wet and moist place as moisture may damage the motor and other mechanical parts.
●Do not pick up sharp objects, eg. nails, to prevent damage to the vacuum cleaner.
●Do not block the air flow.
Any blockages or obstructions to the suction inlet,
●Do not pick up matches, fireplace ashes, or smoking material with cleaner, as a possible fire hazard may result.
●To clean the cleaner body and attachments, wipe them with a
●Avoid cleaning the switch part with a wet cloth and splashing water on it as moisture may cause a short circuit.
●The carbon brushes of the motor are of special composition. When replacing the defaced carbon brushes, it is necessary to use the Hitachi special carbon brushes for the Hitachi Vacuum Cleaner.
●Your vacuum cleaner is not a toy. Do not allow children to play with the cleaner. Do not leave cleaner connected to an electrical outlet and leave it unattended.
●Warning; Electric shock could occur if used outdoors or on wet surfaces.
This product conforms with the protection requirements of council directives 89/336/ECC relating to electromagnetic compatibility and 73/23/ECC relating to electrical equipment designed for use within certain voltage limits.
2
3 | 15/07/2004, 4:07 PM |