Honeywell TE322ELW user manual Power, Main Unit, Dimensions, Clock, Remote Sensor

SNOOZE

When the time alarm sounds, press the SNOOZE/LIGHT button to temporarily stop it. After the SNOOZE/LIGHT is depressed, the time alarm sound will resume in four minutes. If the alarm is not disabled after that, it will sound for two more minutes and then will stop by itself.

BACKLIGHT

The backlight feature is enabled only after the time is set. To activate the backlight press the SNOOZE/LIGHT button once, and both – clock and weather station displays - will light up for five seconds.

PRECAUTIONS

This product is engineered to give you years of satisfactory service if handled carefully. Here are a few precautions:

•Do not immerse the units in water.

•Do not clean the units with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuits.

•Do not subject the product to excessive force, shock, dust, temperature, or humidity, which may result in malfunctions, shorter lifespan, damaged batteries, and damaged parts.

•Do not tamper with the units internal components. Doing so will invalidate the warranty and may cause damage. These units contain no user-serviceable parts.

•Use only fresh batteries. Do not mix new and old batteries.

•Read the user's manual thoroughly before operating the units.

17

TROUBLESHOOTING

Check here before contacting customer service.

Issue	Symptom	Solution
Main unit	US Atomic Time	Place unit by the
	signal is not received	window and keep it
		there overnight
Remote sensor	Cannot locate remote	Check batteries
	sensor	Check location
		Press and hold DOWN
		( ) button on the main
		unit to search for the
		signal form the remote
		sensor
	Cannot change the	Press "RESET" after
	channel	setting the channel
	Cannot change the ºC	Press "RESET" after
	to ºF and back	setting ºC/ºF
	Data does not match	Initiate manual sensor
	data on the main unit	search (Press and hold
		DOWN ( ) button on
		the main unit)

18

SPECIFICATIONS			Power
Main Unit			Main unit: 2 AA size (UM-3) 1.5V batteries (not included)
Indoor Temperature	: 23.0°F to 122.0°F		Remote Sensor: 2 AAA size 1.5V batteries (not included)
Proposed operating range			Dimensions
Temperature resolution	(-5°C to +50°C)		Main unit: 3.5(L) x 7.09(H) x 1.18(D) inches
	: 0.2°F (0.1°C)		Remote sensor: 2.35(L) x 3.77(H) x 0.86(D) inches
User-selectable (°F or °C) temperature display
Weather Forecast in five large graphic icons: Sunny, Partly			FCC STATEMENT
Cloudy, Cloudy, Rainy and Snowy
			This device complies with Part 15 of the FCC Rules.
Maximum number of remote sensors	: 3 (one included)
			Operation is subject to the following two conditions: (1)
Readings update interval	: every 45 seconds
EL backlight			This device may not cause harmful interference, and (2)
Low battery indicators – for each remote channel and main unit			This device must accept any interference received, including
Clock			interference that may cause undesired operation.
Precise atomic time			Warning: Changes or modification to this unit not expressly
4 US Time Zones			approved by the party responsible for compliance could
12/24 hour time format			void the user’s authority to operate the equipment.
Crescendo 4 minutes alarm with 5 minutes snooze			NOTE: This equipment had been tested and found to comply
Remote Sensor			with the limits for a Class B Digital device, pursuant to
Remote Temperature			Part 15 of the FCC Rules. These limits are designed to
Proposed operating range with alkaline	: -4°F to + 158°F		provide reasonable protection against harmful interference
batteries
			in a residential installation. This equipment, installed and
	(-20°C to + 70°C)
Proposed operating range with lithium			used in accordance with the instructions, may cause harmful
	°	°	interference to radio communications.
batteries	: -38.8 F to +158 F		There is no guarantee that interference will not occur in a
	°	°
Temperature resolution	(-38.8 C to + 70 C)		particular installation. If this equipment does cause harmful
	: 0.1°C/0.2°F
RF Transmission Frequency	: 433 MHz		interference to radio or television reception, which can be
RF range	: Maximum 328		determined by turning the equipment off and on, the user is
Temperature transmission cycle	feet (100 meters)		encouraged to improve or correct turning the interference
	: approximately		by one or more of the following measures:
Low battery indicator	45 seconds		•	Reorient or relocate the receiving antenna
Wall-mount of Table stand			• Increase the separation between the equipment and receiver.
			•	Connect the equipment to an outlet on a circuit different
			•	from that to which the receiver is connected.
				Consult the dealer or an experienced radio / TV technician
				for help.
19				20