FRONT/REAR View

A. WEATHER AND TIME IN EASY-TO READ DIGITS B. SNOOZE/LIGHT button

•Stops the clock’s alarm temporarily

•Activates a backlight for 5 seconds

C.CHANNEL button

•Recalls a different remote sensor reading – 1,2 or 3

•Activates the remote channels auto-scan feature

•Activates the remote channels search

D.UP () button

•Increases the parameters

•Activates US Time Zone selection mode

•Activates manual search for atomic time signal

•Enables time alarms (W) and (S) and Ice Warning Alarm

E.MODE button

•Toggles between time modes - time with seconds and time with the day of the week

•Activates clock’s manual programming mode

F.DOWN ( ) button

•Decreases the parameters

•Activates manual remote channels search

•Disables time alarms (W) and (S) and Ice Warning Alarm

G.ALARM button

•Allows toggling between the calendar display and three time alarm modes

•Allows programming available alarms

H.MEM button

•Toggles between current, minimum, maximum readings of the indoor and remote

•Clears the temperature memory

I.WALL- MOUNT RECESSED HOLE

•Keeps the unit on the wall

J.BATTERY COMPARTMENT

•Accommodates 2 (two) UM-3 or AA 1.5V alkaline batteries

K.REMOVABLE TABLE STAND

•Holds unit in upright position on a flat surface

REMOTE SENSOR

FEATURES

•New double-tool design

•Remote temperature transmission to the main unit via 433 MHz frequency

•Case can be wall mounted using built-in hanger

•Selection of the temperature display in Celsius or Fahrenheit

•Three channel selection

•LCD displays temperature, and channel

A F

C D

A.LED INDICATOR

•Flashes once when the remote sensor transmits a reading to the main unit.

•Flashes twice when battery power is low.

B.BATTERY COMPARTMENT

•Holds two AAA-size batteries

C.RESET

•Resets all previous settings

D.CHANNEL SWITCH

•Selects the desired channel -1, 2 or 3

E.WALL-MOUNT RECESSED OPENING

•Keeps the remote sensor on the wall

F.°C/ °F SWITCH

•Selects the temperature display in Celsius or Fahrenheit

BEFORE YOU BEGIN

• We recommend using alkaline batteries for the remote sensor and main unit when temperatures are above 32°F (0°C). We recommend using lithium batteries for the remote sensor when temperatures are below 32°F (0°C).

• Avoid using rechargeable batteries. (Rechargeable batteries cannot maintain correct power requirements).

• ALWAYS install batteries in the remote sensor before the main unit.

• Insert batteries before first use, matching the polarity in the battery compartment

• Press RESET after each battery change with a paper clip or similar tool.

• Remove protective plastic screen from LCD display (if any).

• During an initial setup, place the main unit close to the remote sensor.

• After reception is established (the remote temperature will appear on the main unit’s display), position the remote sensor and the main unit within the effective transmission range of 328 feet (100 meters).

• The remote sensor can be placed indoors or outdoors, depending on the area where the temperature is intended to be measured. If you intend measuring outdoor elements, place remote sensor outdoors.

• The main unit must be placed indoors.

NOTE:

1.Avoid pressing any buttons on the main unit before the remote readings are displayed.

2.The effective operating range may be influenced by the surrounding building materials and how the receiver and transmitter are positioned.

3.Place the remote sensor so that it faces the main unit (receiver), minimizing obstructions such as doors, walls, and furniture.

4.Though the remote sensors are weather-resistant, they should be placed away from direct sunlight, rain or snow. The best suggested location for the remote sensor for outdoors is under the eave on the north side of the building.