LBI-38378
Later Front Cover Assembly Keypad Flex Removal
To remove the Keypad Flex, first remove the UDC Flex/UDC/Monitor Button/PTT Switch assembly as pre- viously stated. Next remove the screw securing the emer- gency switch support (G) then remove the support. Remove the knobs using the hex driver. With a spanner wrench, re- move the nuts securing the volume and channel controls and carefully slide the controls inside the radio. Unscrew the two (2) screws that secure the J10/P10 connection at the bottom of the LCD Board. Remove the screws, the plate and the rubber pad. The Keypad Flex is now free for removal.
Speaker Flex Removal
In order to replace the Speaker Flex, it must be
LCD Board Access
To remove the LCD Board, partial removal (actually re- positioning of the top areas) of the Keypad Flex is required. UDC Flex/UDC/Monitor Button/PTT Switch assembly re- moval is not necessary.
After the top areas of the Keypad Flex have been freed as previously outlined, the LCD Board can be removed. At this point is the disassembly process an earlier Front Cover Assembly has two (2) screws on the left side as view from the back (J and JJ) and a later assembly has a single screw in the upper
Printed in U.S.A.
18