Eagle Electronics EVR-150 manual Ring & Beep Volume Ring Volume and Beep Volume

4.Press ENT (repeatedly if necessary) to display the YES/NO confirmation.

5.Press ENT to confirm the new channel name tag or the deletion, then press ESC to return to the menu.

3-3 RING & BEEP Volume (RING VOLUME) and (BEEP VOLUME)

Set the volume level of the incoming signal beeps (RING VOLUME) and/or the error and warning beeps (BEEP VOLUME) to HIGH (high) or LOW (low) as follows:

RADIO SETUP

CH NAME >RING VOLUME BEEP VOLUME

RING VOLUME >HIGH

LOW

BEEP VOLUME >HIGH

LOW

OFF

1.Select RADIO SETUP, then RING VOLUME or BEEP VOLUME as appropriate.

2.Select a HIGH or LOW volume. (It is possible to turn the beeps off completely by selecting BEEP VOLUME then OFF.)

3.Press ENT to enable the new volume setting and return to the menu.

3-4 Internal Speaker Connections (INT SPEAKER)

Switch the radio’s internal speaker ON (on) or OFF (off ). The external speaker is always ON (on) if a speaker is plugged into the external speaker jack.

		1.	Select RADIO SETUP, then INT
RADIO SETUP	INT SPEAKER		SPEAKER.
RING VOLUME	>ON	2. Select ON (on) or OFF (off ) then press
BEEP VOLUME	OFF
			ENT to enable the setting and return
>INT SPEAKER
			to the menu.

3-5 Set the Priority Channel (WATCH MODE)

An EVR-150 operating on USA or Canadian channel banks, you can set the priority channel to cover both CH16 and CH09 as well as the working channel, as follows:

		1.	Select RADIO SETUP, then WATCH
RADIO SETUP	WATCH MODE
			MODE.
BEEP VOLUME	>ONLY 16CH	2.	Select ONLY 16CH for dual watch
INT SPEAKER	16CH+9CH
			mode, or 16CH+9CH for tri watch
>WATCH MODE
			mode.

EAGLE - EVR-150 Installation and Operation Instructions 27