Eagle Electronics EVR-150 manual Fix the DSC label, Connect the Radio Cables

Fix the DSC label

!CAUTION

A DSC warning label is supplied with the EVR-150. To comply with FCC regulations, this warning label must be affixed in a location that is clearly visible from the operating controls of this Eagle radio. Make sure that the chosen location is clean and dry before applying this label.

Connect the Radio Cables

The connectors are on the rear of the base unit, as follows:

1.GPS/COM connector. For connection to GPS device via NMEA. See the following table for wiring and color codes. (If you’re not using this, be sure to put the protective cap securely over the connector to protect it from moisture and dust.)

2.External Speaker connector. Plug the external speaker cable jack into the connector BEFORE powering on the radio. Use a 4 Ohm 4 Watt external speaker.

3.RED Power wire. Connect this to the POSITIVE (+) battery terminal. Check that a 10 Amp fuse is installed on this power cable close to the battery.

4.BLACK Power wire. Connect this to the NEGATIVE (-) battery terminal.

5.ANT. A radio antenna is not supplied. A suitable radio antenna must be mounted and connected before operating the EVR-150 radio. Consult your dealer for advice if necessary.

6.GND. A ground connection is not usually required.

1

5

2

3
4	6

EAGLE - EVR-150 Installation and Operation Instructions 9