Midland Radio 74-250(C) manual From the clock display

•From the clock display:

1.Press and release the “FUNC/SNOOZE” once to change from clock to alert display.

•You will see on the display in most cases “NO MESSAGE” scrolling across the screen. This message will depend on if you have received any alerts recently. Above the message you will see on the right center of the display “COUNTY” followed by a number (1-9) (as described earlier). This number is the county/channel location presently in use.

2.Press and hold “SET” button until you see six digits on the display. The number next to the word “COUNTY” will flash.

The six numbers are the county (fips) code. Refer to the instructions above on how to acquire the FIPS code

2.Press the “UP” button to select the county code/memory location you desire (1-9). This number will flash indicating you are able to change that digit.

There are nine county code/channel memory locations available. Each location can have a different county code and channel if desired.

4.Press and release the set button. The first digit of the county code will flash indicating you are able to change that digit.

Each press of the “SET” button will allow you to change each digit with the “UP/DOWN” buttons on the side of the radio. The digits will flash indicating you can change that digit

5.Press and release the “UP/DOWN” buttons to change the digit.

6.Press and release the “SET” button to move to the next digit.

9