2.TX/RX INDICATOR: The TX/RX light in the upper right corner of the front panel lights in red color when the microphone button is pressed and transmitter is in operation. It lights in green color when the microphone button is released and the receiver is in operation.
PUSH-TO-TALK MICROPHONE
The receiver and transmitter are controlled by the
RECEIVE OPERATING PROCEDURE
1.Place the
2.Turn the set on by turning the VOLUME CONTROL clockwise, past click. NOTE: Microphone must be plugged in for receiver to operate.
3.Set the VOLUME CONTROL to a comfortable level.
4.Set the Mode Selector Switch to the desired mode.
5.Listen to the background noise from the speaker. Turn the SQUELCH CON- TROL slowly clockwise, until the noise just disappears. The Squelch is now properly adjusted. The receiver will remain quiet until a signal is received. Do not advance the control too far, or some of the weaker signals will not be heard.
6.Set the Channel Selector to the desired channel.
7.Adjust the CLARIFIER to clearly receive SSB or AM signals.
TRANSMITOPERATINGPROCEDURE
1.Select the desired channel of transmission.
2.If the channel is clear, depress the
WARNING
Operation of this equipm~nt requires a valid station license issued by the Department of Communications. Do not transmit with your equipment until you have a license.
MAINTENANCE AND ADJUSTMENT
This transceiver is especially designed for the environment encountered in mobile installations. The use of all solid state circuitry and its light weight result in high reliability. Should failure occur, however, replace parts only with identical parts. Do not substitute.
(NOTE: When ordering parts, it is essential to specify the correct model number and serial number of the unit.)