•Do not try to repair the units. Contact La Crosse Technology for Repairs.
|
|
|
| TROUBLESHOOTING |
|
|
|
| |
|
|
|
| |
| Problem | The Projection is faint | ||
| Solution | 1) | Use AC adapter | |
| 2) | Darken surroundings | ||
|
| 3) | Use fresh batteries (if AC is not used) | |
| Problem | The LCD is faint. | ||
| Solution | Replace the batteries. | ||
| Problem | “OFL” appears in the indoor temperature LCD. | ||
|
| 1) | Move unit to an area with warmer or cooler surrounding | |
| Solution | temperature. | ||
| 2) | Current surrounding temperatures are outside measuring | ||
|
| range. | ||
| Problem | No reception of WWVB signal. | ||
|
| 1) | It may help reception to face the front of the projection | |
|
|
| alarm in the general direction of Ft. Collins, Colorado. | |
|
| 2) | Wait overnight for signal. | |
| Solution | 3) | Be sure the projection alarm is at least 6 feet from any | |
|
| electrical devices, i.e. TV sets, computers, or other radio | ||
|
|
| controlled clocks. | |
|
| 4) | Remove batteries for five minutes, reinsert and leave the | |
|
|
| unit alone overnight without pressing buttons. | |
|
| 5) | If problems persist contact La Crosse Technology. | |
| Problem | Hour is incorrect (minute is correct). | ||
| Solution | Be sure correct time zone and daylight saving time are | ||
| selected. | |||
| Problem | |||
|
| 1) | Check batteries in remote | |
| Solution | 2) | If batteries are replaced in remote, the unit must be re- | |
| started. Remove all batteries, and then follow start up | |||
|
| procedure. | ||
| Problem | “OFL” appears in the outdoor temperature LCD | ||
|
| 1) | Remote temperature is out of range. | |
| Solution | 2) | Check batteries. | |
| 3) | Interference from an outside source (cordless telephone, | ||
|
|
| etc.) | |
|
|
| 19 | |