Replacement of Batteries

TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER (INSTALL BATTERIES IN TRANSMITTER BEFORE INSTALLING BATTERIES IN RADIO-CONTROLLED CLOCK)

The transmitter uses 2 x AA,1.5V batteries. To install and replace the batteries, please follow the steps below:

1.Remove the battery cover by pushing down towards bottom of transmitter and sliding cover out.

2.Insert the batteries, observing the correct polarity (see marking inside battery compartment).

3.Replace the battery cover on the unit.

ALKALINE BATTERIES ARE RECOMMENDED FOR USE IN BOTH UNITS. AVOID USING RECHARGEABLE BATTERIES.

TO INSTALL AND REPLACE BATTERIES IN THE RADIO-CONTROLLED CLOCK

The radio-controlled clock uses 2 x AA, 1.5V batteries. To install and replace the batteries, please follow the steps below:

1.Remove the battery cover.

2.Insert batteries observing the correct polarity (see marking inside battery compartment).

3.Replace compartment cover.

DO NOT SET THE CLOCK.

Note:

In the event of changing batteries of the unit, ensure that the batteries do not spring free from the contacts. Always wait at least 15 minutes after removing the batteries before reinserting, otherwise start up and transmission problems may occur.

For best performance, batteries should be replaced at least once a year to maintain the best running accuracy. Ensure that the batteries used are new and the correct size.

Please help in the preservation of the environment and return used batteries to an authorized depot.