Note: When using the AC adaptor, plug into the projection alarm first and then into the electrical outlet (this will help avoid pressing any buttons inadvertently).
3)Wait 10 minutes for WWVB reception and remote temperature.
4)If there is no WWVB reception, manually set the time and date (instructions in the Program Mode).
5)Program the settings.
6)Mount the
7)Mount the transmitter where remote temperature measurement is desired (on the North side of a house for example).
Note: The remote transmitter is weather resistant but not waterproof. High humidity and mist will not damage the transmitter but direct rain will. The maximum range between the transmitter and projection alarm is 80ft. open air (no obstructions). Any resistance (i.e. walls, furniture, etc) between the two will decrease the effective operating range.
8)The projector will activate and remain on if the alarm clock is plugged in. If only batteries are used, the projector will only be activated when a button is pressed.
9)See the “Features” section III. for instructions on projection direction, etc.
DETAILED
I.BATTERY INSTALLATION
A. REMOTE TEMPERATURE TRANSMITTER
1.Remove the battery cover. Observing the correct polarity, install 2 AA batteries. The batteries will fit tightly (to avoid
2.Replace the battery cover.
4