Contents | Connections | Playback | Settings | Tips | Appendix |
Switching the function of the volume buttons on the remote control
When the function of the VOLUME df buttons on the remote control is set to “Variable”, the analog audio output level can be adjusted.
AMP (Default) : Adjusts the volume of Marantz amplifiers.
Variable : Adjusts the analog audio output level of the analog audio signal output from this unit.
%
•Check the operation of this unit and connected devices after setting the function of the VOLUME df buttons on the remote control.
Set the function of the volume buttons on the remote control to “Variable”
1Press and hold the ENTER and number 1 button down together for more than 5 seconds.
The remote mode selection button (REMOTE MODE CD) lights for approximately 1 second.
Set the function of the volume buttons on the remote control to “AMP”
1Press and hold the ENTER and number 2 button down together for more than 5 seconds.
The remote mode selection button (REMOTE MODE NET) lights for approximately 1 second.
NOTE
•The remote control returns to the factory settings when the batteries are removed. Therefore, set the remote control code again after replacing the batteries.
NOTE
•To adjust the analog audio signal output from this unit using the remote control, also set “Audio Out” (vpage 55) to “Variable”.
|
|
|
|
|
|
|
| 57 |
|
|
|
|
|
Front panel |
|
| Display |
|
| Rear panel |
| Remote |
|
| Index |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|