Player
Getting Started
Unpack
Make sure your player includes the following accessories:
•Headphones
•Two 1450mAH NiMH rechargeable batteries
•AC Adapter
•Remote Control
•PC/Mac Software CDs
•Carry Case
•Car Kit (power and cassette adapters)
•Quick Start Poster
Getting Started
Contents | Index 8 |
6Connect the supplied AC adapter to the DC In Jack on the side of the player, and into an electrical outlet. Let the batteries charge for approximately five hours before using the player.
NOTE: To charge the batteries, the player must be turned off. The RioVolt will play CDs when plugged into the AC Adapter, but it can not charge the batteries while playing CDs. After the rechargeable batteries have been charged the first time, subsequent charges should only take approximately three to four hours to reach 100% capacity.
RioVolt MP3/WMA >> CD
Insert Batteries
1Press the OPEN button to release the latch and open the RioVolt player.
2Remove the cardboard insert.
3Open the battery compartment cover on the inside of the RioVolt.
4Insert the two supplied batteries. Ensure that the batteries are inserted properly by matching the + and - symbols on the battery with the symbols on the RioVolt.
5Close the battery compartment cover and close the RioVolt player.
Connect Headphones
Connect the supplied headphones to the MULTIFUNCTION PORT on the side of the player.
If you are using the remote control, plug the headphones into the remote control, then plug the remote control into the MULTIFUNCTION PORT.
Tip: You can also use the LINE OUT jack to connect the player to an external audio system (cable not included) or the included Car Kit.