PROGRAMMED PLAYBACK
1.Press the PLAY/PAUSE( ) button and after 3 seconds the STOP( ) button.
2.Press the PROG. button. The track number and 'PROG' will flash on the display indicating the first selection.
3.Press BACKWARD ( ) or FORWARD ( ) button to select the desired track to be programmed. The track number which will be p rogrammed will flash on the display.
4.Press the PROG. button to enter the track into memory.
5.Repeat the steps 2 and 4 to program up to 24 tracks.
6.Press PLAY/PAUSE ( ) button once to start programmed playback.
7.To cancel programmed playback, press the STOP( ) button and then press the PROG. button for 3 seconds to exit the programming.
Note: Programmes can be set in Stop mode only.
During program playback, if you wish to repeat the entire programmed playback,
press the MODE button repeatedly until the ( | ) indicator appears on the |
display. |
|
SPECIALFUNCTIONS
Dynamic Bass Boost
Set the BASS BOOST switch to “ ON ” position to enjoy a more powerful Bass sound. Note: Since Bass Boost performance will change depending on the volume level,
sound may be distorted if the volume is set too high.Lower the volume level until the sound quality is improved.
Hold switch
You can lock the controls on your CD player to prevent accidental button presses. Slide HOLD switch to the “ ON “ position, if a button is pressed when the hold function is active “HOLD” will be shown in the display.
Auto Power Off
When the unit is stopped (standby mode) for approximately 60 seconds, the Auto Power Off function will activated and turn the unit off automatically.
EN - 7
MAINTENANCE
Cleaning the unit
Wipe the outside surface of the unit with a soft cloth moistened with water and mild soap.
Handling CDs
Your CD player has been especially designed for the reproduction of compact discs bearing the CD mark. No other discs should be loaded into the player.
Always place the disc in tray with the label facing up.
Although compact discs are impervious to wear during play, damage to the surface of a disc through improper handling will result in playback irregularities.
To preserve your compact discs, please handle them with care.
Although minute dust particles and fingerprints should have no effect on playback, you should keep the surface of the recorded side of your discs clean by wiping the disc with a clean, dry,
Never use record cleaners, record sprays, antistatic sprays, liquids or chemical based liquids to clean the surface of a disc. They may in fact irreparably damage the disc's plastic surface.
Always return the disc to its protective plastic case when not using it. Avoid exposing discs to direct sunlight, excessive temperatures or high humidity for extended periods of time. Do not write on the label side of the disc with a ball/point pen as this may scratch the disc.
SPECIFICATIONS
Audio |
|
D/A conversion | |
Frequency response | |
Wow and flutter | Below measur able limits |
No. of channels | 2 channels (stereo) |
Output level | Line output: 0.6V rms (47KW ) |
| Phone: 15mW (32W) |
Bass Boost effect (100Hz) | + 6 dB |
General |
|
Power r equiremen ts | |
| - DC in 4.5V jack accepts AC power adaptor |
| (centre positive) |
Power consumption | 0.8W (DC 3V) |
Note: Specifications and the design are subject to possible modifications without notice due to improvement.
EN - 8