Installation
English
■Removing the hard rubber frame
1Engage the catch pins on the removal tool and remove the two locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Catch
Lock
Accessory2 Removal tool
2When the lower level is removed, remove the upper two locations.
■Removing the Unit
1Refer to the section “Removing the hard rubber frame” and then remove the hard rubber frame.
2Remove the screw (M4⋅8) on the back panel.
3Insert the two removal tools deeply into the slots on each side, as shown.
Screw (M4X8) | Accessory2 Removal tool |
(commercially |
|
available) |
|
4Lower the removal tool
toward the bottom, and pull out the unit halfway while pressing towards the inside.
The frame can be removed from the top side in the same manner.
Be careful to avoid injury from the catch pins on the removal tool.
5Pull the unit all the way out with your hands, being
careful not to drop it.
— 14 —