Problem, No sound /power CD skips tracks

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING: Do not open the set as there is a risk of electric shock. Under no

		circumstances should you try to repair the set yourself, as this will
		invalidate the guarantee.
Problem			Note:
–	Possible cause		Make sure the CD is not encoded with copy-
			right protection technologies, as some do not
•	Remedy
			conform to the Compact Disc standard.

No sound /power

–Volume not adjusted

•	Adjust the VOLUME	–	CD damaged or dirty
		•	Replace or clean CD
–	Power cord not securely connected
		–	Program/shuffle is active
• Connect the AC power cord properly
		•	Quit program/shuffle mode
– Batteries dead/ incorrectly inserted

•	Insert (fresh) batteries correctly	Note: A CD badly scratch or dirty may result in
–	CD contains non-audio files	improper operation.
•	Press ∞ , § once or more to skip to a CD audio
	track, instead of the data file.	Sound skips during MP3 playback

		– MP3 file made at compression level exceeding
Display does not function properly / No			320kbps
reaction to operation of any of the		• Use a lower compression level to record CD
			tracks into MP3 format
controls
		–	Disc damaged or dirty
–	Electrostatic discharge
		• Replace or clean disc

•Switch off and unplug the set. Reconnect after a few seconds

–No CD inserted

• Insert a CD

–CD badly scratched or dirty

•Replace/ clean CD, see Maintenance

– Laser lens steamed up

•Wait until lens has cleared

–CD-R/CD-RW is blank or not finalized

•Use a finalized CD-R/CD-RW or suitable CD Audio disc only