Panasonic SL-CT350 operating instructions Audio CD-DA, United Kingdom, Continental Europe

Specifications

Audio (CD-DA)

Play time:

Sampling frequency:

44.1 kHz

Using on a flat stable surface at

No. of channels: 2 (left and right, stereo)

25 eC, EQ is off, Hold is on and

Dear

Frequency response:

Anti-skip is on POS 1 (CD-DA). Play

Operating Instructions

20 Hz to 20,000 Hz (i0.5 dB to j7 dB)

times are in hours and approximate.

Customer

RMS max. 6 mWi6 mW/16 ≠(adjustable)

Batteries

Play

Portable CD Player

Thank you for

Headphone output level:

used

time

Pickup

780 nm

2 alkaline batteries (LR6)

60

product.

Wavelength:

purchasing this

Light source:

Semiconductor laser

2 alkaline batteries (LR03)

26

Before connecting,

(NORSK)

4 alkaline batteries

86

SL-CT345

operating or

Bølgelengde

780 nm

(2 LR03r2 LR6)

adjusting this

Laserstyrke

2 optional rechargeable batteries

Ingen farlig stråling sendes ut

16

product, please

(Europe: HHR-4AGE/2B

(med sikkerhets-beskyttelse)

Other areas: HHR-4AGT/2B)

read these

SL-CT350

instructions

General

2 optional rechargeable

Power supply:

(Europe: HHR-4AGE/2B

76

completely. Please

SL-CT345

Other areas: HHR-4AGT/2B) and

keep this manual

2 alkaline (LR6) batteries

DC input (via AC adaptor, not included):

SL-CT352

for future reference.

DC 4.5 V

≥Play time will be considerably

DC 4.5 V

Recharging time: About 3.5 to 4.5 hours

SL-CT350

SL-CT352

≥The play time may be less depending

DC input (via included

AC adaptor):

on the operating conditions.

AC adaptor input:

reduced when playing CD-RW.

Note:

(The United Kingdom)

Dimensions (WaHaD):

“EB” on the packaging

AC 220 –240 V

50/60 Hz

136.7 mma21.5 mma136.7 mm

(Continental Europe)

Mass:

180 g (with batteries)

indicates the United

AC 220 –230 V

50/60 Hz

157 g (without batteries)

Kingdom.

(Australia and N.Z.)

Operational temperature range:

AC 230 –240 V 50 Hz

0 eC–40 eC

(Sets purchased in Japan)

Rechargeable temperature range:

AC 110 –127 V/ 220 –240 V 50/60 Hz

5 eC–40 eC

SL-CT350

SL-CT352

Note:

Power consumption:

Specifications are subject to change

Using AC adaptor:

0.8 W

without notice.

EB

EG

GN

SG

p

Recharging:

3.0 W

Mass and dimensions are approximate.

Matsushita Electric Industrial Co., Ltd.

Web Site: http://www.panasonic.co.jp/global/

RQT7830-B

F1104SZ0

Troubleshooting guide References to the remote control apply only to SL-CT352.

Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the solutions indicated in the chart do not solve the problem, consult your dealer for instructions.

No play.			≥The HOLD function is on. Cancel HOLD (➪page 4).
			≥The batteries may be depleted (➪page 3).
			≥The disc isn’t correctly set.
			≥The disc is scratched or dirty. (Tracks may be skipped.)
			≥There is moisture on the lens. Wait for about an hour and then try again.
			≥The lens is dirty: clean it with a blower (recommended
			product: SZZP1038C). If the lens gets marked with
			fingerprints, gently wipe them off with a cotton swab.
No sound or there			≥Ensure the plugs are inserted firmly.
is a lot of noise.			≥Wipe the plugs with a clean cloth.
			≥The disc is scratched or dirty.
			≥The elapsed play time disappears and sound is
			interrupted if bumps continue repeatedly.
Play doesn’t resume			≥This doesn’t work during random play.
from the track where			≥It may not work correctly under some conditions.
play stopped at.
Play doesn’t start			≥Random play modes may be on (➪page 4).
from the first track.			≥Play resumes from the track where you last stopped play
			(➪page 4, Play). (If the lid is opened while the unit is
			turned off, the resume function may not be cancelled.)
Cannot specify point A or B.			You may not be able to specify point A or B at the end of a disc.
Cannot change the			If [:] or [9] is pressed before [MEMO] you
anti-skip mode.			cannot change the mode.
	SL-CT352		Be sure to connect other equipment through the remote
	The unit	malfunctions	control. If speakers are connected directly to the unit,
when connected to			they should have an impedance of 1 k≠ or less.
other equipment.
Cannot hear the remote			The operation tone may be turned off (➪page 4).
control’s operation tone.
The remote control			≥Remove the plug and reinsert it as fully as possible.
does not work properly.			≥Use only the included remote control to operate the unit.
Cannot recharge.			≥You aren’t using the special rechargeable batteries (➪page 3).
			≥You must insert two batteries before you can charge.
			≥The unit must be off before you can charge.
The AC adaptor becomes			This is normal.
warm during recharging.

The batteries are taking The batteries may take as long as 4.5 hours to recharge a long time to recharge. under some conditions.

Play time is short ≥This may occur the first time you charge the batteries

after recharging. or if you haven’t used them for a long time. Play time should be restored after a few recharges.

≥The batteries can go flat if you leave the AC adaptor connected after charging is complete.

≥If play is extremely short even after fully recharging the batteries, the batteries may have exceeded their life (Rechargeable batteries can be recharged approximately 300 times). Please purchase new nickel-metal hydride rechargeable batteries (Europe: HHR-4AGE/2B Other areas: HHR-4AGT/2B).

The battery indicator ≥The indicator does not appear when the AC adaptor is connected. fails to appear or is ≥The indicator may not appear correctly when using the

incorrect.rechargeable and dry cell batteries at the same time and under certain conditions.

The unit stops working. Disconnect then reconnect all power sources (batteries and AC adaptor).

Power cuts off. If you connect or disconnect the AC adaptor, the power cuts off even if the batteries are inserted.

Display

(The HOLD function is on. Cancel HOLD (➪page 4).

)≥You haven’t inserted a disc or it isn’t inserted correctly. ≥You have inserted a disc this unit cannot play.

*The disc lid is open.

' The program already contains 20 tracks.

Maintenance

If the surfaces are dirty wipe with a soft, dry cloth.

≥Never use alcohol, paint thinner or benzine to clean this unit.

1≥Before using chemically treated cloth, read the instructions that came with the cloth carefully.