TROUBLE SHOOTING GUIDE
SYMPTOM | CAUSE | SOLUTION | |
|
|
| |
CD Player will not | Dead or weak batteries. | Replace both batteries. | |
The AC adaptor not | Check the AC adaptor connection at AC | ||
turn on. | |||
| connected properly. | outlet and side of set. | |
| Disc inserted incorrectly | ||
| Defective or wrong type | Try another audio compact disc. | |
| compact disc. | ||
|
| ||
Disc will not play. | CD door not closed. | Close lid securely (push down left corner | |
|
| of door) | |
| Moisture has condensed | Take out the CD and leave the CD door | |
| open for about an hour to dry the | ||
| inside the CD deck. | ||
| moisture condensation. | ||
|
| ||
| Headphone plug not | ||
| inserted properly. | headphone jack (marked phones). | |
|
|
| |
| Headphone plugged into | Plug headphone into the headphone | |
| the line out jack. | jack (not the line out jack). | |
No sound from |
|
| |
The volume control set to | Increase the volume. | ||
headphones | minimum | ||
| |||
|
|
| |
| Weak batteries. | Replace with fresh batteries or use the | |
| AC adaptor. | ||
|
| ||
| Defective compact disc. | Try another compact disc. | |
|
|
| |
| The compact disc or lens is | Clean or replace the compact disc or | |
| dirty. | clean the lens with a camera brush or | |
Sound is skipping |
| blower. | |
Too much movement of the | Reduce movement of CD player. | ||
| |||
| CD player. |
| |
| Music is too loud. | Decrease the volume control level. | |
|
|
| |
Sound in distorted | Weak batteries. | Batteries are getting weak, replace both | |
batteries or use the AC adaptor. | |||
|
|
| |
| Bass boost is on and | Lower volume control or slide bass | |
| music is too loud. | boost switch to off. | |
Tracks do not | Batteries are too weak and | Replace both batteries with fresh | |
change or set does | the battery symbol will | alkaline batteries, or use a AC Adaptor. | |
not play normally | show in display | ||
| |||
|
|
| |
| Electronic or static error | Remove batteries and AC adaptor. | |
Buttons do not | Wait a few seconds and | ||
caused circuitry to lock. | Make sure batteries are fresh or adaptor | ||
work |
| has power. | |
|
| ||
|
|
| |
| The HOLD function is on. | Slide the HOLD switch to OFF position. | |
|
|
|
E.7