Class l Laser Product

. Avoid installing this unit in places

exposed to direct sunlight or close to

heat radiating appliances such as

electric heaters, oo top of other stereo

equipment that radiates too much heat, places lacking ventilation or dusty areas, places subject to constant vibration and/

or humid or moist areas.

. Do not attempt to clean this unit with

chemical solvents as this might damage the finish. Use a clean dry cloth.

. Operate controls and switches as

described in the manual.

. Before turning 'On'the power, make

certain that power cord is properly

installed.

. Store your CDs, cassettes in a cool area

to avoid damage from heat.

. When moving the set, be sure to first disconnect the power cord.

CLASS 1 LASER PRODUCT

CAUTION

APPAREIL A LASER DE CLASSE 1

INIVISIBLE LASER RADIATION

WHEN OPEN AND INTERLOCKS

PRODUCTO LASER DE CLASE 1

DEFEATED.

AVOID EXPOSURE TO BEAM

This product contains a low power Laser Device.

FGG lnformation

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuantto Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. Howevel there is no guarantee that interference will not occur in a

particular installation. lf this equipment does cause harmful interference to radio ortelevision

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

. Reorient or relocate the receiving antenna.

. lncrease the separation between the equipment and receiver.

'Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

. Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1t; fnis device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.