Normal CD Playback

•Make sure you have installed the batteries.

•Make sure the HOLD switch on the wired remote control is set to the ‘Off’(left) position.

•Make sure to set the VOL control to a low setting before you put on the headphones.

IMPORTANT:

This CD player can play normal CDs plus CD Recordable (CD-R) and CD ReWritable (CD-RW) discs. However the playability of CD-R/RW discs may be affected by the type of software that was used in ‘ripping’the tracks from the original discs and ‘burning’the tracks onto the blank media. Playability may also be affected by the quality and condition of the blank media you use for recording. 100% compatibility cannot be guaranteed. This is not an indication of any problems with your player.

1.) Slide the CD door OPEN switch to the ‘right’to unlock and open the CD door.

2.) Place your CD on the center spindle with the printed label side facing up. Press downward on the disc near the center hole until the disc is fully seated on the spindle.

3.) Close the CD door and connect the headphones to the PHONES jack by pushing the headphone plug into the PHONES jack as far as it will go.

4.) Press the (Play/Pause) button to begin playback. The display will briefly show “60 SEC”, then “ – – ” flashes while the player reads the disc.

The total tracks and playing time will appear briefly in the display and then the playback will begin on track “01”. The display will show the elapsed playing time of the track being played.

HD9116_041006.p65

10/4/2006, 9:10