Compaq ML370 manual Post Error Messages, Error Code, Probable Source of Problem Recommended Action

3-8Compaq ProLiant ML370 Maintenance and Service Guide

Table 3-2

POST Error Messages

	Error Code	Audible Beeps	Probable Source of Problem	Recommended Action
A Critical Error		None	A catastrophic system error,	Run Diagnostics. Replace failed
occurred prior to this			which caused the server to	assembly as indicated.
power-up			crash, has been logged.
Unsupported		1 long, 1 short	Processor not supported by	Check documentation for
Processor Detected			current system ROM	supported processors, and if
System Halted				supported, remove the
				processor and update the
				system to latest ROM.
FATAL ROM ERROR:		1 long, 1 short	ROM programmed in factory	Replace the physical ROM part.
The System ROM is			incorrectly
not properly
programmed
101	- ROM Error	1 long, 1 short	System ROM checksum	Run Diagnostics. Replace failed
				assembly as indicated.
101	- I/O ROM Error	None	Options ROM checksum	Run Diagnostics. Replace failed
				assembly as indicated.
102	- System Board	None	DMA, timers, and so on	Replace the system board. Run
Failure				the Compaq System
				Configuration Utility.
104	- ASR-2 Timer	None	System board failure	Run Diagnostics. Replace failed
Failure				assembly as indicated.
105	- Current System	2L	Non-booted ROM image is	Flash the ROM utilizing
ROM is corrupt—			corrupt	ROMPaq.
now booting
redundant System
ROM
162	- System	2S	Configuration incorrect	Run the System Configuration
Options Not Set				Utility and correct.
163—Time & Date		2S	Invalid time or date in	Run the System Configuration
Not Set			configuration memory	Utility and correct.
164	- Memory Size	2S	Configuration memory incorrect	Run the System Configuration
Error				Utility and correct.
172	- Configuration	None	Nonvolatile configuration corrupt	Run the System Configuration
Nonvolatile Memory			or jumper installed	Utility and correct.
Invalid
173	- Slot ID	None	Board replaced, configuration not	Run the System Configuration
Mismatch			updated	Utility and correct.
174	- Configuration/	None	PCI board not found	Run the System Configuration
Slot Mismatch Device				Utility and correct.
Not Found

continued