Compaq ML370 Scsi cable None, Error detected, System halted Scsi controller, Imminent Failure

Diagnostics and Troubleshooting 3-13

Table 3-2

POST Error Messages continued

Error Code Audible Beeps Probable Source of Problem Recommended Action

1702 - SCSI cable	None	Termination or cabling problem
error detected;		with the system board integrated
system halted.		SCSI controller.

Refer to cabling diagrams in Chapter 2 of this guide, the cabling guidelines on the Compaq website, and your Compaq server documentation.

1703 - SCSI cable	None	Incorrect cabling	Ensure that the integrated SCSI
error detected.			controller has SCSI termination
Internal SCSI cable			attached.
not attached to
system board
connector. System
halted.
1720 - Slot x Drive	None	Prefailure condition	Indicated drive has reported a
Array—SMART hard			SMART predictive-failure
Drive Detects			condition and may fail at some
Imminent Failure			time in the future. If drive is part
SCSI: Port n:			of a non-fault-tolerant
SCSI ID x			configuration, back up all data
			before replacing drive and
			restore all data afterward. If
			drive is part of a fault-tolerant
			configuration do not replace the
			drive unless all other drives in
			the array are online. Press F1 to
			resume.
1721 - Slot x Drive	None	Monitor and performance	Replace the drive when it is
Array—Drive		threshold exceeded condition.	reasonable for you to do. The
parameter tracking			drive has not failed, but Compaq
predicts imminent			recommends you replace the
failure. The following			drive.
devices should be
replaced when
conditions permit. Do
not replace drive
unless all other
drives in the array
are online! Back up
data before replacing
drive(s) if using
RAID 0.
			continued