Compaq ML370 manual Following Scsi Been recovered, Drives need, Automatic Data, Select F1 to retry

Diagnostics and Troubleshooting 3-21

Table 3-2

POST Error Messages continued

Error Code	Audible Beeps	Probable Source of Problem	Recommended Action
1786 - Drive Array	None	System is in Interim Data	Press F1 to allow Automatic
Recovery Needed.		Recovery mode. Data has not yet	Data Recovery to begin. Data
The following SCSI		been recovered.	will automatically be restored to
drive(s) need			drive X now that the drive has
Automatic Data			been replaced or now seems to
Recovery: SCSI			be working.
port 1: SCSI ID 0.			Or
Select F1 to continue
			Press F2 and the system will
with recovery of data
			continue to operate in the
to drive. Select F2 to
			interim Data Recovery mode.
continue without
recovery of data to			The “previously aborted”
drive.			version of the 1786 POST
Or			message will appear if the
			previous rebuild attempt was
Slot 1 Drive Array
			aborted for any reason. Run
Recovery needed.			Drive Array Advanced
Automatic Data			Diagnostics (ADU) for more
Recovery previously			information. If the replacement
Aborted! The			drive was failed, try using
following SCSI			another replacement drive. If
drive(s) need			rebuild was aborted due to a
Automatic Data			read error from another physical
Recovery: SCSI			drive in the array, back up all
port 1: SCSI ID 0.			readable data on the array, run
Select F1 to retry			Diagnostics Surface Analysis,
			and then restore your data.
Automatic Data
Recovery to drive.
Select F2 to continue
without starting
Automatic data
Recovery data to
drive.

1787 - Slot x Drive	None	Hard drive X failed or a cable is
Array Operating in		loose or defective. Following a
Interim Recovery		system restart, this message
Mode. The following		reminds you that drive X is
SCSI drive(s) should		defective and fault tolerance is
be replaced: SCSI		being used.
port (y): SCSI ID (x)

1.Replace drive X as soon as possible.

2.Check loose cables.

3.Replace defective cables.

continued