Compaq ML370 manual 200-299, Memory Test Error Codes

3-28Compaq ProLiant ML370 Maintenance and Service Guide

200-299, Memory Test Error Codes

The 200 series of diagnostic error codes identifies failures with the memory subsystem.

Table 3-4

Memory Test Error Codes

Error Code	Description	Recommended Action
200-xx	Invalid memory configuration.	Reinsert memory modules in correct location and retest.
201-xx	Memory machine ID test failed.	1.	Replace the system ROM and retest.
202-xx	Memory system ROM checksum	2.	Replace the processor board and retest.
	failed.	3.	Replace the memory expansion board and retest.
203-xx	Memory write/read test failed.	1.	Replace the memory module and retest.
204-xx	Memory address test failed.	2.	Replace the processor board and retest.
205-xx	Walking I/O test failed.	3.	Replace the memory expansion board and retest.
206-xx	Increment pattern test failed
207-xx	Invalid memory	Replace DIMMs.
	configuration-check DIMM
	installation. DIMMs installed
	have 8K refresh.

208-xx	Invalid memory speed detected -
	check DIMM installation. Slow
	DIMMs may cause data loss.

Replace DIMMs with timing greater than 60 ns.

209-01	RAM long test failed.	1.	Replace the memory module/board and retest.
209-02	Error while saving test block.	2.	Replace the system board and retest.
209-03	Error while restoring test block.	3.	Replace the memory expansion board and retest.
209-89	ECC error during testing.
210-xx	Random pattern test failed.	1.	Replace the memory module and retest.
		2.	Replace the processor board and retest.
		3.	Replace the memory expansion board and retest.
211-01	RAND test failed.	1.	Replace the memory module/board and retest.
211-02	Error while saving test block	2.	Replace the system board and retest.
211-03	Error while restoring test block
211-04	Insufficient memory to perform the
	test
211-05	Failed inverted pattern compare,
	but RAM was correct
211-89	ECC error during testing
214-01	Data error during noise test	1.	Replace the memory module/board and retest.
214-89	ECC error during testing	2.	Replace the system board and retest.
215	Non-functioning DC-DC converter	Replace the DC-DC converter (Processor Power
	for processor X	Module).